Problem with EM358 on Creator

After powering off and then back up my matrix creator and RPI4, I’m seeing this when I check the hardware:

pi@matrix-creator:~ $ sudo /usr/share/matrixlabs/matrixio-devices/matrix-init.bash
**** MATRIX Creator FPGA has been programmed!
INFO: [/dev/matrixio_regmap] was opened
FPGA IDENTIFY = 5c344e8
FPGA VERSION = 1000a
*** MATRIX Creator initial process has been launched
md5sum: /tmp/em358_dump: No such file or directory
*** Running the program instead of the bootloader
Running the program instead of the bootloader
SAM3 MCU was programmed before. Not programming it again.

Going deeper:

pi@matrix-creator:/usr/share/matrixlabs/matrixio-devices $ sudo openocd -f  cfg/em358_check.cfg
Open On-Chip Debugger 0.10.0-dev-g6165f43c-dirty (2019-06-27-05:36)
Licensed under GNU GPL v2
For bug reports, read
        http://openocd.org/doc/doxygen/bugs.html
BCM2835 GPIO config: tck = 17, tms = 4, tdi = 22, tdo = 27
BCM2835 GPIO config: trst = 18
trst_only separate trst_push_pull
adapter speed: 200 kHz
Warn : em357.bs.bs: nonstandard IR value
Warn : Specify TAP 'em357.cpu.cpu' by name, not number 0
cortex_m reset_config vectreset
Info : BCM2835 GPIO JTAG/SWD bitbang driver
Info : JTAG only mode enabled (specify swclk and swdio gpio to add SWD mode)
Info : clock speed 200 kHz
Error: JTAG scan chain interrogation failed: all zeroes
Error: Check JTAG interface, timings, target power, etc.
Error: Trying to use configured scan chain anyway...
Error: em357.cpu.cpu: IR capture error; saw 0x00 not 0x01
Warn : Bypassing JTAG setup events due to errors
Error: Invalid ACK (0) in DAP response
Error: Invalid ACK (0) in DAP response
Error: Invalid ACK (0) in DAP response
Error: Invalid ACK (0) in DAP response
Error: Invalid ACK (0) in DAP response
Error: Invalid ACK (0) in DAP response
Error: Invalid ACK (0) in DAP response
Error: Invalid ACK (0) in DAP response
Error: Invalid ACK (0) in DAP response
Error: Invalid ACK (0) in DAP response
Error: Could not initialize the debug port
Error: Target not examined yet

I’m not sure, but is my EM 358 trashed? What does that do here anyways?