What should I do after MATRIX-OS and HAL for Z-WAVE

Until now, I’ve installed MATRIX-OS AND HAL . And I’ve done the MATRIX Creator/Voice Hardware Test with this instruction https://community.matrix.one/t/matrix-creator-voice-hardware-test/1310.

All is well done except Raspberry Pi GPIO Status.
What I got is


gpiochip0: GPIOs 0-53, parent: platform/3f200000.gpio, pinctrl-bcm2835:
gpio-6 ( |sysfs ) in hi IRQ

gpiochip2: GPIOs 100-101, brcmvirt-gpio, can sleep:
gpio-100 ( |led0 ) out lo

gpiochip1: GPIOs 128-135, brcmexp-gpio, can sleep:
gpio-135 ( |led1 ) in hi


Not the same with instruction. How should I configue raspi-config to get the same ?

And I’ve test and creat simple APP.

But by now what should I do to build a Z-WAVE network with MATRIX CREATOR ? I‘m not very clear now. Could you give some other instructions?